PSS PS600 Manual del operador descargar pdf (Pagina 39)

Condition Possible Cause Corrective Action

Forms are mishandled in the

folder or damaged during

sealing.

Dirty folding rollers. Clean rollers with cleaning

solution. See page 39.

Folding roller adjusted

improperly or worn; sealing

rollers adjusted improperly.

Contact your Pressure Seal

distributor for advice.

Forms not sealing. Pressure on sealing rollers

is relieved.

Reset pressure on the

sealing rollers. See page 34.

Forms in wrong way round. Replace forms correctly.

Forms have been incorrectly

stored, or are older than

their shelf life (one year).

Use fresh forms.

Fold plate form stop(s)

adjusted improperly causing

poor registration of adhesive

strips.

Check and adjust position of

the fold plate form stop(s).

See page 16.

Sealing rollers adjusted

improperly.

Contact your Pressure Seal

distributor for advice.

Forms are misfeeding. In-feed tray form guides are

set too tight or too loose.

Set the guides so there is

just enough clearance to

allow the form to move freely

between the guides.

Debris in folding plates;

folding plates not installed

properly; fold plate form

stop(s) adjusted improperly.

Remove debris; properly

install folding plates; check

and adjust the position of

the fold plate form stop(s).

Separator block not set up

correctly.

Contact your Pressure Seal

distributor for advice.

Vacuum not set up properly. See page 22.

PS 300 5. Operation Errors

22-01-03 Iss. B. Page 37

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46 47

Comentarios a estos manuales

Sin comentarios

PSS PS600 Manual del operador Pagina 39

Comentarios a estos manuales