PSS PS600 Manual del operador descargar pdf (Pagina 22)

C fold set-up

Refer to Figure 9.

1. Measure the length of the folds required.

2. Adjust the form stop for each folding plate to the measurement you determined

previously in step 1 as follows:

Loosen the locking knob at the centre of the form stop.

Slide the stop along the rods until the stop aligns with the correct settings on

the scales. Use the fine adjustment control to make sure the scales on each

side of the folding plate show the same settings otherwise the form will not fold

squarely.

Tighten the locking knob.

3. If the new form is a different width from the last form used, refer to ‘Adjusting

the form guides’ on page 22.

4. Re-install both folding plates.

3. Set-up PS 600

Page 18 22-01-03 Iss. B.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 46 47

Sin comentarios

PSS PS600 Manual del operador Pagina 22