PSS PS600 Manual del operador descargar pdf (Pagina 26)

Setting up the In-feed Bed

Set up the in-feed bed as follows:

3. Set-up PS 600

Page 22 22-01-03 Iss. B.

Adjust so that air flow

causes paper to float tightly

on in-feed bed

Close all air jets outside the

paper stack

Adjust backstops so that

paper can not move

backwards by more than 1mm

Adjust side beds so that paper is

held in place with no more than

1mm of sideways movement

Turn to adjust side

beds

Turn to adjust

back stop

Turn to adjust paper

infeed angle

Turn to adjust air

flow onto in-feed bed

Seperator block should be

approximately 4mm from mounting bar

Adjust so that the vacuum pickup point

aligns with the seperator block

4mm

Turn to adjust height

of seperator block

Turn to adjust

distance of seperator

block from mounting

bar

Height of seperator block should be 2

thickness (of the paper to be

processed)with medium friction

between the seperator block and the

suction roller

Vacuum pick

up point

Suction roller

Figure 11: Setting up the In-Feed Bed

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 46 47

Sin comentarios

PSS PS600 Manual del operador Pagina 26